Hobart 6801 Manuel d'utilisateur télécharger pdf (Page 13)

– 7 –

PL-40838-1

LOWER GUIDE HOLDER

LOWER BLADE GUIDE ASSEMBLY

LOWER BLADE GUIDE

The lower blade guide assembly fits in the lower guide holder (Fig. 12). The blade fits in the slots of

both the steel saw blade guide and the plastic guide. When the right table is removed and the plastic

guide is hinged up, the lower blade guide assembly can be removed for cleaning by lifting it out of the

lower guide holder.

The steel saw blade guide is available in various widths depending on the blade being used. Contact

Service to change the steel saw blade guide for other blade widths.

Fig. 12

REMOVING THE BLADE

Remove the upper and lower pulley covers. Raise the gauge plate to its vertical position. Remove

the right table by lifting its right side and sliding the table to the right to free it from the locating pins.

Remove the column guard. Turn the tension adjuster counterclockwise until it stops (this will release

tension on the blade by raising the lower pulley). Raise the plastic blade guide on the lower blade guide

assembly and release the blade from the upper and lower blade guides. Free the blade from the blade

scrapers in the lower pulley area and release it from the pulleys. Remove the blade.

Make sure the pulleys are properly installed and the pulleys are latched (Figs. 7 & 8). Install the new

blade with the teeth pointing to the right and down as you face the front of the saw. The blade must

fit between the V's on the blade scrapers, in the slots of the upper and lower blade guides, and must

not touch any of the pulley flanges. The lower blade guide must be installed after the blade is installed.

When the blade is in position, see BLADE TENSION, below, to adjust the tension properly. Refer to

LOWER BLADE GUIDE, above, if the blade width of the new blade is different than the old. Reinstall

any removed parts.

BLADE TENSION

After the blade has been installed, set the blade tension by turning the tension adjuster clockwise until

it stops.

6801 Meat Saw Technical Manual Page 13 of 51

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 50 51

Pas de commentaire

Hobart 6801 Manuel d'utilisateur Page 13